Rohde & Schwarz Scope Rider RTH1004 - Page 220

Protocol Analysis
R&S
®
Scope Rider RTH
220User Manual 1326.1578.02 ─ 12
Source.........................................................................................................................220
Polarity........................................................................................................................ 220
Standard......................................................................................................................220
Bit rate, Predefined Bit Rates......................................................................................221
Threshold, Technology, Find Level............................................................................. 221
Source
Sets the source of the data line. All active analog channels can be used.
If option R&S RTH-B1 is installed, digital channels can also be used as source.
Remote command:
BUS:LIN:DATA:SOURce on page 465
Polarity
Defines the idle state of the bus. The idle state is the recessive state and corresponds
to a logical 1.
"Idle Low"
The bus is idle (state = 1) when the signal is low
"Idle High"
The bus is idle (state = 1) when the signal is high
Remote command:
BUS:LIN:POLarity on page 466
Standard
Selects the version of the LIN standard that is used in the DUT. The setting mainly
defines the checksum version used during decoding.
The most common version is v2.x. For mixed networks, or if the standard is unknown,
set the LIN standard to "Auto".
Remote command:
BUS:LIN:STANdard on page 466
LIN (Option R&S
RTH-K3)