Network Connections
R&S
®
Scope Rider RTH
295User Manual 1326.1578.02 ─ 12
There are two ways to connect via wireless LAN:
●
Usually, the R&S RTH is the access point and you set up connection on the porta-
ble device.
●
The R&S RTH is the client that connects to a router or access point.
As any other wireless LAN connection, also the WLAN connection between the
R&S RTH and the mobile device can be disturbed by various influences, for example,
interfering signals.
To enable wireless LAN
1.
Press the
key.
2. Tap "Wireless LAN".
3. Only for option R&S RTH-K200: Select the "Country", where you use the instru-
ment.
The list contains all countries where the wireless LAN option has been approved.
You also can find the list in the data sheet.
4. Enable "Wireless State".
Now you can connect the instrument.
To use the instrument as access point
1.
Press the
key.
2. Tap "Wireless LAN".
3. Only for option R&S RTH-K200: Select the "Country", where you use the instru-
ment.
The list contains all countries where the wireless LAN option has been approved.
You also can find the list in the data sheet.
4. Select "Wireless Mode" = "Access Point" in the "Wireless LAN" menu.
5. If you connect for the first time, change the default "Passphrase". You can also
change the identifier of the instrument, the "SSID".
6. Enable "Wireless State".
7. On your portable device, set up the connection to the instrument. Select the SSID,
and enter the passphrase.
The detailed procedure is described in the documentation of your portable device.
To use the instrument as client
1.
Press the key.
2. Tap "Wireless LAN".
3. Only for option R&S RTH-K200: Select the "Country", where you use the instru-
ment.
Wireless LAN Connection (Option R&S
RTH-K200/200US)
To Next Page
Loading...
