Rohde & Schwarz Scope Rider RTH1004 - Page 343

Remote Control Commands
R&S
®
Scope Rider RTH
343User Manual 1326.1578.02 ─ 12
Parameters:
<Position> Voltage value of the range
CALCulate:MATH:VERTical:POSition <Position>
Moves the math waveform or down in the diagram.
Parameters:
<Position> Position value, given in divisions.
15.4.5 Reference Waveforms
REFCurve:SOURce....................................................................................................... 343
REFCurve:UPDate.........................................................................................................343
REFCurve:STATe........................................................................................................... 343
REFCurve:POSition....................................................................................................... 343
REFCurve:NAME...........................................................................................................344
REFCurve:SAVE............................................................................................................344
REFCurve:OPEN........................................................................................................... 344
REFCurve:DELete......................................................................................................... 344
REFCurve:SOURce <Source>
Selects the waveform to be taken as reference waveform.
Parameters:
<Source> C1 | C2 | C3 | C4 | M1
*RST: C1
REFCurve:UPDate
Creates the reference waveform from the source waveform.
Usage:
Event
REFCurve:STATe <State>
Activates or deactivates the reference waveform.
Parameters:
<State> ON | OFF
REFCurve:POSition <Position>
Sets the vertical position of the reference waveform.
Parameters:
<Position> Default unit: DIV
Waveform Analysis