Rohde & Schwarz Scope Rider RTH1004 - Page 360

Remote Control Commands
R&S
®
Scope Rider RTH
360User Manual 1326.1578.02 ─ 12
See:
●
SPECtrum:WAVeform:MAXimum[:ENABle] on page 358
●
SPECtrum:WAVeform:MINimum[:ENABle] on page 358
●
SPECtrum:WAVeform:SPECtrum[:ENABle] on page 359
●
SPECtrum:WAVeform:AVERage[:ENABle] on page 358
Suffix:
<m>
.
1..2
Parameters:
<TraceSource> SPECtrum | MAXimum | MINimum | AVERage
*RST: SPECtrum
SPECtrum:CURSor<m>:COUPling <State>
Couples the cursor lines so that the distance between the two lines remains the same
if one cursor is moved.
Suffix:
<m>
.
1..2
irrelevant
Parameters:
<State> ON | OFF
*RST: OFF
SPECtrum:CURSor<m>:SCPLing <State>
If enabled, the position of the cursor lines is adjusted if the vertical or horizontal scales
are changed. The cursor lines keep their relative position to the waveform.
If disabled, the cursor lines remain on their position on the display if the scaling is
changed.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: ON
SPECtrum:CURSor<m>:FREQuency[:VALue] <Frequency>
Queries the frequency at the specified cursor.
Suffix:
<m>
.
1..2
Spectrum Analysis