Rohde & Schwarz Scope Rider RTH1004 - Page 359

Remote Control Commands
R&S
®
Scope Rider RTH
359User Manual 1326.1578.02 ─ 12
Parameters:
<State> ON | OFF
*RST: OFF
SPECtrum:WAVeform:SPECtrum[:ENABle] <State>
Displays the clear/write spectrum trace.
Parameters:
<State> ON | OFF
*RST: ON
SPECtrum:FREQuency:RESet
Clears the results for previous measurements used in statistical evaluation (see
SPECtrum:WAVeform:AVERage[:ENABle], SPECtrum:WAVeform:MAXimum[:
ENABle], SPECtrum:WAVeform:MINimum[:ENABle] and SPECtrum:
FREQuency:AVERage:COUNt on page 356).
Usage:
Event
15.6.2.2 Cursor Measurements in Spectrum Mode
Special cursor commands are available for the Spectrum mode.
SPECtrum:CURSor<m>:STATe....................................................................................... 359
SPECtrum:CURSor<m>:SOURce....................................................................................359
SPECtrum:CURSor<m>:COUPling.................................................................................. 360
SPECtrum:CURSor<m>:SCPLing....................................................................................360
SPECtrum:CURSor<m>:FREQuency[:VALue]...................................................................360
SPECtrum:CURSor<m>:FREQuency:DELTa?...................................................................361
SPECtrum:CURSor<m>:LEVel[:VALue]?.......................................................................... 361
SPECtrum:CURSor<m>:LEVel:DELTa?............................................................................ 361
SPECtrum:CURSor<m>:SCReen.................................................................................... 362
SPECtrum:CURSor<m>:STATe <State>
Enables or disables the spectrum cursor measurement.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
SPECtrum:CURSor<m>:SOURce <TraceSource>
Selects the trace on which the cursors are placed. Only active traces are available.
Spectrum Analysis