Rohde & Schwarz Scope Rider RTH1004 - Page 362

Remote Control Commands
R&S
®
Scope Rider RTH
362User Manual 1326.1578.02 ─ 12
SPECtrum:CURSor<m>:SCReen
Sets the cursors to a default position on the screen.
Suffix:
<m>
.
1..2
Usage: Event
15.6.2.3 Markers in Spectrum Mode
Special marker commands are available for the Spectrum mode.
SPECtrum:MARKer[:STATe]............................................................................................362
SPECtrum:MARKer:COUNt............................................................................................ 362
SPECtrum:MARKer:SOURce.......................................................................................... 362
SPECtrum:MARKer:SETup:DISTance.............................................................................. 363
SPECtrum:MARKer:SETup:EXCursion.............................................................................363
SPECtrum:MARKer:SETup:MLEVel................................................................................. 363
SPECtrum:MARKer:RCOunt?......................................................................................... 363
SPECtrum:MARKer:RESult<m>:FREQuency[:VALue]?......................................................364
SPECtrum:MARKer:RESult<m>:FREQuency:DELTa?........................................................364
SPECtrum:MARKer:RESult<m>:LEVel[:VALue]?............................................................... 364
SPECtrum:MARKer:RESult<m>:LEVel:DELTa?.................................................................365
SPECtrum:MARKer:RMARker:FREQuency?.....................................................................365
SPECtrum:MARKer:RMARker:VALue?.............................................................................365
SPECtrum:MARKer[:STATe] <State>
If enabled, a peak search is performed on the current spectrum results.
Parameters:
<State> ON | OFF
*RST: OFF
SPECtrum:MARKer:COUNt <NumberOfMarkers>
Defines the number of markers used to indicate peaks in the spectrum results. With 3
active markers, the 3 peak values in the spectrum are indicated.
Parameters:
<NumberOfMarkers> Range: 1 to 15
Increment: 1
*RST: 3
SPECtrum:MARKer:SOURce <TraceSource>
Determines the trace used for the peak search.
Spectrum Analysis