Remote Control Commands
R&S
®
Scope Rider RTH
411User Manual 1326.1578.02 ─ 12
COUNter<m>:READ?
Starts a new measurement, returns the current measurement result and stays in run
mode.
Suffix:
<m>
.
1..2
Return values:
<Counter result> Measured frequency
Usage: Query only
COUNter<m>:SENSe:FUNCtion
[<Function>]
Selects the input channel for the counter.
Suffix:
<m>
.
1..2
Parameters:
<Function> 'FREQ 1' | 'FREQ 2' | 'FREQ 3' | 'FREQ 4'
Depends on available channels.
COUNter<m>:SENSe:RANGe <MeterRangeUI>
This command defines the measurement range.
Suffix:
<m>
.
1..2
Parameters:
<MeterRangeUI> Range: 0.1 to 300
Increment: 0.1
*RST: 0.1
COUNter<m>:SENSe:REFerence:STATe <ReferenceSource>
Selects the reference to be used for the counter.
Suffix:
<m>
.
1..2
Parameters:
<ReferenceSource> INTernal | EXTernal
EXTernal
The measured value of counter 2 is used as a reference. Specify
the nominal reference frequency for counter 2 using
COUNter<m>:SENSe:REFerence:VALue.
INTernal
An internal reference is used to determine the counter fre-
quency.
Counter Mode (R&S RTH-K33)
To Next Page
Loading...
