Storing and Loading Instrument Data - File Key R&S SMB
1407.0806.32 4.22 E-2
Exclude Frequency - File
The current frequency is retained when a stored instrument setting is
loaded.
Remote-control command:
SOUR:FREQ:RCL EXCL
Exclude Level - File
The current level is retained when a stored instrument setting is
loaded.
Remote-control command:
SOUR:POW:RCL EXCL
Recall - File
Loads the selected configuration.
If an instrument setting in which a sweep was activated is stored, the
sweep is started when the recall command is called.
If an instrument setting which accesses lists is stored, this list is also
loaded.
If the list has been deleted in the meantime, an error message
appears when the instrument setting is loaded. If the list has been
overwritten in the meantime, the new entries will be used.
Remote-control command:
*RCL 2
Recall Immediate x
Loads the selected configuration from one of the three intermediate
memories.
If an instrument setting in which a sweep was activated is stored, the
sweep is started when the recall command is called.
If an instrument setting which accesses lists is stored, this list is also
loaded.
If the list has been deleted in the meantime, an error message
appears when the instrument setting is loaded. If the list has been
overwritten in the meantime, the new entries will be used.
A message appears if no instrument configuration is stored in this
memory.
Remote-control command:
*RCL 1
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com
To Next Page
Loading...
