R&S SMB Switching to Manual Control - Local Key
1407.0806.32 4.17 E-2
Protection Level 1 can be deactivated to expand the functionality of the internal adjustment, to change
the host name and to access the self tests (see service manual). The password is 123456.
Remote-control command:
SYST:PROT1:STAT ON
SYST:PROT1:STAT OFF, 123456
Save Recall - Setup-Setting
The Save/Recall submenu can also be called up with the FILE key and is therefore described in the
section on this key (see section "Storing and Loading Instrument Data - File Key", page 4.19).
Help - Setup-Help
The Help submenu offers comprehensive online help for the R&S SMB Signal Generator. A desired
topic can be selected via the table of contents (select Manual) or the index (select Index).
For context-sensitive information about a marked parameter, press the
HELP key. For a description of
the Help menu, refer to the section covering to the HELP key (see section "Help System - Help Key",
on page 4.18).
Switching to Manual Control - Local Key
In remote control mode a status message appears in the display header. The rest of the display
remains unchanged and shows the current instrument status, i.e. the status which exists under the
remote control settings. The instrument can be operated (e.g. menus can be opened). However, it is not
possible to enter or change values.
The status message additionally indicates whether the
LOCAL key is disabled or enabled (see also
Chapter 5, Chapter 5 , section "Switch-Over to Remote Control").
If the REMOTE status message is shown, the
LOCAL key switches the instrument from remote control
to manual control. The current command must be fully processed before the mode is switched,
otherwise the instrument switches immediately back to remote control.
If the REM-LLO status message (remote local lockout) is displayed, the instrument can be switched
from remote control to manual control by means of remote control only (e.g. with the Visual Basic
command CALL IBLOC (generator%)); the
LOCAL key is disabled. The key is disabled by remote
control with the interface message LLO.
When switching from remote to manual control, the display update suppression function, if active
(
SETUP - GUI Update is Off), is automatically deactivated ( SETUP - GUI Update is On).
To Next Page
Loading...
