Rohde & Schwarz SMB 100a - Data out of Range (-222); Data Type Error (-104); Device-Specific Error (-300); Exponent too Large (-123)

R&S SMB Alphabetical List of SCPI-Error Messages
1407.0806.32 9.5 E-2
Data out of range (-222)
A value of the transmitted command was outside the legal range.
Example:
Command SOUR:FREQ only permits entries in the range of min to
max frequency.
SCPI:
Execution error - sets bit 4 in the ESR register
Data type error (-104)
The command contains an invalid value indication.
Example:
ON is indicated instead of a numeric value for frequency setting -
:FREQ ON is not allowed.
SCPI:
Command error - sets bit 5 in the ESR register
Device-specific error (-300)
Device-specific error not defined in greater detail.
SCPI:
Device-specific error - sets bit 3 in the ESR register
Exponent too large (-123)
The magnitude of the exponent is too large.
SCPI:
Command error - sets bit 5 in the ESR register
Expression data not allowed (-178)
The command contains a mathematical expression at an impermissible position.
SCPI:
Command error - sets bit 5 in the ESR register
GET not allowed (-105)
A Group Execute Trigger (GET) is within a command line.
Note:
A Group Execute Trigger (GET) is only allowed at the end of a
command line or in a separate command line.
SCPI:
Command error - sets bit 5 in the ESR register
Hardware error (-240)
A legal program command or a query could not be executed because of a hardware
problem in the device.
SCPI:
Execution error - sets bit 4 in the ESR register