R&S SMB Putting into Operation
1407.0812.62 1.15 E-2
Connecting the R&S SMB to the AC Supply
The R&S SMB is automatically matched to the applied AC voltage (see rear panel). There is no need to
set the voltage manually or change fuses. The AC supply connector is at the rear of the unit (see
below).
Switching On
! Connect the signal generator to the AC supply by means of the
supplied power cable.
Since the instrument is a protection class I Equipment, it should only
be connected to a socket with a protective earth contact.
! Press the main power switch at the rear of the instrument to
position I.
! After power-up the instrument is either ready for operation
(STANDBY) or in operating mode, depending on the state of the
ON/STANDBY switch on the instrument front (see below).
Note: The power switch may remain on for any period of time. Switching
off is required only if the instrument should be completely isolated
from the AC supply.
! Press the ON/STANDBY switch on the front panel; the green LED
must be on.
! After booting the software, the instrument is ready for operation. All
modules in the instrument are supplied with power.
Start Display and Booting the R&S SMB
After instrument switch-on, the Linux operating system boots first and then the instrument firmware.
During booting of the instrument firmware, a selftest is performed. After booting is completed, the block
diagram of the signal generator is displayed and the instrument is ready to be operated. The settings
that were active before the last switch-off are established unless another start setting has explicitly been
selected in the File menu.
Note: If the software stops unexpectedly, the instrument can be shut down by pressing the STANDBY
key for approx. 5 s.
To Next Page
Loading...
