R&S SMB General Instrument Settings
1407.0806.32 4.11 E-2
Date and Time - Setup-Environment
The Date/Time... menu provides access to the system time and date settings. It is opened using the
SETUP
or MENU key under Environment. The time is used on the internal controller.
Date
Enters the date in the format day.month.year.
Remote-control command: SYST:DATE 2007,03,20
Time
Enters the time in the format hour.minute.second.
Remote-control command: SYST:TIME 23,59,59
Network Settings - Setup-Environment
The Network Settings... menu provides access to the network settings. It is opened using the SETUP
or MENU key under Environment. The R&S SMB is equipped with a network interface and can be
connected to an Ethernet LAN (local area network). How to connect the signal generator to the network
is described in Chapter 1, Section "Connecting the R&S SMB to a Network (LAN)".
ATTENTION
Risk of network errors!
Connecting errors may affect the entire network.
We recommend to coordinate the connection of the instrument to the network with
the network administrator.
Do not connect or disconnect the network cable until the instrument is switched
off (standby). Only then the network connection can be reliably detected and
impairments to instrument operation can be avoided.
To Next Page
Loading...
