General Instrument Settings R&S SMB
1407.0806.32 4.12 E-2
The menu is divided into the sections Common Settings where the general network environment is
defined, IP Address section where the specific identification of the computer in the network is defined,
and DNS Server Settings where the DNS server is entered.
New entries are only accepted after the Accept button is pressed.
Accept - Network Settings
Accepts a new entry or selection and changes the settings
accordingly.
Remote-control command:
SYST:COMM:NETW:DNS:SET
SYST:COMM:NETW:COMM:SET
SYST:COMM:NETW:IPAD:SET
The indications of the menu menu are only updated after pressing the Get System Settings button.
Get System Settings
Retrieves the current system settings of the instrument.
The indications in the network menu are only updated after pressing
this button.
Remote-control command: SYST:COMM:NETW:GET
Hostname
Enters the individual computer name of the R&S SMB.
Note:
The computer name can only be changed after protection level 1 is
deactivated (see section "Protection - Setup-Protection")
A new entry is only accepted and the hostname changed after the
Accept button is pressed.
A predefined name is indicated and can be used for network
connections.
We recommend that connection of the instrument to the network be
coordinated with the network administrator. Connection errors may
affect the entire network.
Remote-control command:
SYST:COMM:NETW:HOST RSSMB100A123456
MAC Address
Indicates the MAC address of the network adapter.
Remote-control command:
SYST:COMM:NETW:MAC?
Mode
Selects if the IP address is assigned automatically or manually or if a
Peer to Peer connection is used.
The selection is only accepted after the Accept button is pressed.
We recommend that connection of the instrument to the network be
coordinated with the network administrator. Connection errors may
affect the entire network.
To Next Page
Loading...
