Pulse Generator Menu R&S SMB
1407.0806.32 4.82 E-2
SOUR:LFO:VOLT 1 V
LF Gen Freq - LF Output
Sets the frequency of the LF generator.
This setting affects all analog modulations which use the LF generator
as the internal modulation source.
Remote-control command:
SOUR:LFO:FREQ 1E3
LF Gen Shape - LF Output
Selects the shape of the LF generator.
Remote-control command:
SOUR:LFO:SHAP SQU
Pulse Generator Menu
The Pulse Generator menu is opened in the Mod Gen function block or using the MENU key under
Mod Gen. The same settings can be made in the Pulse Modulation menu of the MOD block. Please
refer to the description of the menu in section "Pulse Modulation", page 4.72.
Video Sync Signal State -
Pulse Generator
Switches on/off the output of the video/sync signal at the PULSE
VIDEO connector. Pulse modulation of the RF carrier is activated in
the Pulse modulation menu of the Modulation block..
Remote-control command:
SOUR:PGEN:OUTP:STAT ON
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com
To Next Page
Loading...
