R&S SMB General Instrument Settings
1407.0806.32 4.5 E-2
Hardware Config... - Setup-System
In the Hardware Config… menu, the installed assemblies together with their variants and revision
states can be displayed for servicing purposes. The Hardware Config menu is opened using the
SETUP
or MENU key under System.
Section Counter in the upper part of the menu shows the Operation Hours and the number of power-
on (Power On Counter).
Remote-control command:
DIAG:INFO:OTIM? Response: "37"
DIAG:INFO:POC? Response: "147"
A table below lists the installed assemblies. It is divided into the sections Common Assembly and RF
Assembly and Baseband Assembly
Assembly
Assembly name
Part Number
Part Number of assembly
More…
Opens a dialog with additional information on serial number, revision and slot of
assembly and used bus by assembly (serial bus or PCI bus).
Remote-control command (see chapter 'Remote control Commands' for parameter name for modules):
DIAG:BGIN? "RFBO" Response: "1406.7007.00 02.00 123456,MOD-FPGA 20.20.00 "
Gui Update... - Setup-System
In the Start/Stop Gui Update... menu the update of the displayed parameters can be switched off in
order to increase speed for certain settings.
Note:
It is especially recommended to switch off the GUI update for optimum sweep performance with
short dwell times and for fast settling times.
The indicated values are not updated and may therefore differ from the internally used values.
To Next Page
Loading...
