EasyManua.ls Logo

Rohde & Schwarz SMB 100a - Contents - Chapter 9 - Error Messages

Rohde & Schwarz SMB 100a
328 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
R&S SMB Contents - Error Messages
1407.0806.32 I-9.1 E-2
Contents - Chapter 9 - "Error Messages"
9 Error Messages .................................................................................................... 9.1
Introduction - Status Information and Messages..........................................................................9.1
Status Information............................................................................................................................9.1
Error Messages.................................................................................................................................9.3
Alphabetical List of SCPI-Error Messages ....................................................................................9.4
Block data not allowed (-168)...................................................................................................9.4
Character data not allowed (-148) ...........................................................................................9.4
Character data too long (-144).................................................................................................9.4
Command Error (-100).............................................................................................................9.4
Command protected (-203)......................................................................................................9.4
Data out of range (-222)...........................................................................................................9.5
Data type error (-104)...............................................................................................................9.5
Device-specific error (-300)......................................................................................................9.5
Exponent too large (-123) ........................................................................................................9.5
Expression data not allowed (-178) .........................................................................................9.5
GET not allowed (-105)............................................................................................................9.5
Hardware error (-240) ..............................................................................................................9.5
Hardware missing (-241)..........................................................................................................9.6
Header suffix out of range (-114).............................................................................................9.6
Illegal parameter value (-224)..................................................................................................9.6
Invalid block data (-161)...........................................................................................................9.6
Invalid Character (-101) ...........................................................................................................9.6
Invalid separator (-103)............................................................................................................9.6
Invalid suffix (-131)...................................................................................................................9.7
Lists not same length (-226).....................................................................................................9.7
Missing parameter (-109).........................................................................................................9.7
No error (0)...............................................................................................................................9.7
Numeric data not allowed (-128)..............................................................................................9.7
Out of memory (-225)...............................................................................................................9.7
Parameter not allowed (-108)...................................................................................................9.7
Program mnemonic too long (-112) .........................................................................................9.8
Queue overflow (-350) .............................................................................................................9.8
Query interrupted (-410)...........................................................................................................9.8
Query unterminated (-420)......................................................................................................9.8
Query deadlocked (-430) .........................................................................................................9.8
Self test failed ... (-330)............................................................................................................9.8
Settings conflict ... (-221) .........................................................................................................9.9
String data not allowed (-158)..................................................................................................9.9
Suffix not allowed (-138) ..........................................................................................................9.9
Suffix too long (-134)................................................................................................................9.9
Syntax error (-102)...................................................................................................................9.9

Table of Contents

Related product manuals