R&S SMB Introduction - Putting into Operation
1407.0812.62 1.1 E-2
1 Putting into Operation
Introduction - Putting into Operation
Chapter 1, "Putting into Operation" explains the control elements and connectors of the Signal
Generator R&S SMB with the aid of the front and rear views and describes how to put the instrument
into operation. It also describes the connection of peripherals such as keyboard and mouse. A detailed
description of the device interfaces is given in Chapter 8, "Maintenance and Remote Control
Interfaces". Specifications of interfaces can be seen in the data sheet.
Chapter 2, "Getting Started" gives an overview of generator functions and introduces the operating
concept. Detailed operating instructions and an overview of menus follow in Chapter 3, "Manual
Operation".
The complete manual is provided on the CD-ROM in printable pdf-format: Menus and instrument
functions are described in detail in Chapter 4, "Instrument Functions", basics of remote control of the
instrument in Chapter 5, "Remote Control - Basics" and commands for remote control in chapter 6
"Remote Control - Commands". Chapter 9, "Error Messages" contains a list of possible status and error
messages.
Legend for Front Panel View
This section gives an overview of control elements and connectors on the front panel of the R&S SMB.
Each element/connector is briefly described and a reference is given to the chapters containing detailed
information.
Figure 1-1 Front panel view
To Next Page
Loading...
