R&S SMB File Management
1407.0812.62 3.23 E-2
• Load file:
Mark file and load it by clicking the rotary knob or by pressing the Select button/softkey.
• Save file:
Enter file name in the File Name: field. Mark the directory to which the file is to be saved and then
click the Save button/softkey.
• Create file:
Enter file name in the File Name: field. Mark the directory to which the file is to be saved and then
click the Create button/softkey. The created file is empty; it must be filled with the necessary values in
the individual editor.
File Manager
The File Manager allows general file management such as copying, shifting, renaming and deleting
files as well as generating new directories.
The File Manager can be called up in any menu to which files can be saved. Call-up is either at the
level of the small selection menu
or via the File Manager button in the File Select window.
The File Manager can also be called up in the Save/Recall - Setup-Settings menu.
In the upper area, File Type, the File Manager allows the type file selection to be displayed. This can
be used to process either all files (all files (*:*) selection) or a specific selection of files (e.g. user
correction (*.ucor) selection). The table at the end of this section contains a list of the file types.
The available drives and directories are displayed on the left side, the files of the selected directory on
the right side. The currently selected path is displayed above the windows. If the area is opened several
times, the path last selected is displayed. Unlike the File Select window, the File Manager displays the
full file names including extensions.
The buttons trigger the associated actions such as copying, shifting or deleting the marked files. Plus, a
new directory can be created in the level below the marked directory.
Operation is similar to the operation of menus with several areas (see section "Selecting and Exiting a
Menu Area - Setting Parameters", page 3.12): By using the rotary knob or cursor keys, the area is
marked; the entry focus is shifted to this area by clicking the rotary knob or using the Enter key. The
rotary knob and up/down cursor keys will then navigate only within this area. By using the left/right
cursor keys, it is possible to switch between the directory tree and the file list. The subdirectories of the
selected directory will only be displayed after a short delay to allow quick navigation in the directory
tree. Pressing the
ESC key again shifts the entry focus up one level. The buttons/softkeys can be
selected and activated.
• Shift file:
Mark file and then press the Cut button/softkey. Mark the directory to which the file is to be shifted
and then click the Paste button/softkey. If the target directory already contains a file with the same
name, a confirmation query is displayed to confirm overwriting of this file.
• Copy file:
Mark file and then press the Copy button/softkey. Mark the directory to which the file is to be copied
and then click the Paste button/softkey. If the target directory already contains a file with the same
name, a confirmation query is displayed to confirm overwriting of this file.
To Next Page
Loading...
