R&S SMB Putting into Operation
1407.0812.62 1.13 E-2
Safety Instructions
General Precautions
ATTENTION
Instrument damage caused by disregarding the following precautions!
Any non-compliance with the following precautions may cause damage to the
instrument. Prior to putting the instrument into operation, check the following:
− The covers of the housing are in place and screwed on.
− Vents are not obstructed. Make sure that the air can escape freely through the
vents at the sides. The minimum distance to the wall should therefore be at least
10 cm.
− The signal levels at the inputs do not exceed permissible limits.
− The outputs of the instrument are not overloaded or incorrectly connected.
This particularly applies to the maximum permissible back-feed at the outputs,
which is specified in the data sheet
− The ambient temperature must not exceed the range specified in the data sheet.
Please also observe the instructions in the following sections and the general safety
instructions at the beginning of this manual.
Protection against Electrostatics
To avoid damaging the electronic components of the EUT due to electrostatic
discharge produced by contact, the use of appropriate protective measures is
recommended.
To Next Page
Loading...
