Sweep Mode R&S SMB
1407.0806.32 4.50 E-2
Level Sweep Menu
The Level Sweep menu is opened in the RF function block or using the MENU key under RF.
In the top section of the menu, the Level Sweep mode is activated and the level range and the sweep
mode are selected. The buttons are used to reset the level sweep (all sweep modes) or to execute the
level sweep (Single mode).
The sweep range, sweep spacing and dwell time are set in the bottom section.
State - RF Level Sweep
Activates Level Sweep mode.
Note:
Activating the level sweep automatically deactivates the RF sweep
and LF sweep.
Remote-control commands:
SOUR:POW:MODE SWE
SOUR:POW:MODE CW
To Next Page
Loading...
