Rohde & Schwarz SMB 100a - Selecting a Control Element - Setting Parameters; Switching Parameters On;Off - Setting Parameters

R&S SMB Setting Parameters
1407.0812.62 3.11 E-2
Function block in the diagram:
The cursor is set on the first menu in the Winbar. If no menus are open, the current
cursor position remains unchanged.
Function Front panel PC keyboard Mouse
Edits the frequency or level
in the entry fields of the
header area
Press FREQ or LEVEL
key.
Enter value.
Press CTRL + F (frequency)
or CTRL + L (level).
Enter value.
Click the entry field and enter
value.
Activates the block
diagram
Press DIAGRAM key.
Press CTRL + D. Click the function block.
Activates the Winbar Press softkey.
Press WINBAR key.
Press CTRL + F1... F8
Press CTRL + W.
Click button in Winbar.
Calls the Setup or File
menu or the menu tree
Press SETUP , FILE or
MENU key.
Press CTRL + S (Setup),
CTRL + F (File) or CTRL + M
(menu tree).
-
Selecting a Control Element - Setting Parameters
Control elements are always selected in the same way no matter whether a function block in the
diagram, a menu in the menu tree, a parameter in the menu or an entry in a list or table is concerned.
• An element is activated by means of the cursor. An active element is highlighted by a blue frame.
Function Front panel PC keyboard Mouse
Selects an element Select element by means of
the rotary knob or the arrow
keys.
Select element by means of
the arrow keys.
Click element.
Switching Parameters On/Off - Setting Parameters
A parameter can be activated and deactivated using a button or a check box.
• The ENTER function of the different control media switches the highlighted element on or off (toggle
function). Colour and label of a button change, the check box is ticked or the tick is removed.