R&S SMB General Instrument Settings
1407.0806.32 4.7 E-2
The Firmware section of the menu shows the firmware version and the version of the software
platform.
Note:
Your R&S SMB is delivered with the latest firmware version available. Firmware updates as well as
the Release Notes describing the improvements and modifications are provided on the Internet at
the download site of the Rohde & Schwarz SMB home page (www.rohde-
schwarz.com/product/smb100a). This home page always offers the latest information on your signal
generator, e.g. also on changes of the firmware update procedure.
The tables in the sections Hardware and Software list the installed hardware and software options.
Option
Short name of option
More…
Opens a dialog with additional information, e.g. on designation, license
number, and expiration date of option
For regular options, Permanent is indicated in this column.
Some options are available as trial versions. This column shows their
expiration date. After this date, the option is no longer available on the
instrument.
Section Loaded Modules is provided for service purposes. It lists all loaded software modules with
their versions and offers a short description of each module.
Install SW-Option... - Setup-System
Newly purchased software options are enabled in the Install SW-Options... menu.. They are ready to
operate after they are enabled by means of a key code supplied with the option.
Only if the R&S SMB Signal Generator is equipped with an older firmware version, a firmware update
prior to enabling the software option may be required. The information on the valid firmware versions for
the purchased software option is provided together with the option. The firmware update is described in
the service manual instrument, chapter 4 (on CD ROM, supplied with the instrument).
Test Point... - Setup-Test
The Test Point... menu provides access to the test points available in the instrument. When activated,
the voltage of the selected test point is measured and displayed. A detailed description of the test points
can be found in Chapter 3 of the Service Manual (supplied with the instrument).
The Test Point... menu is opened using the
SETUP or MENU key under System.
To Next Page
Loading...
