Rohde & Schwarz SMB 100a - General Configuration of Instrument - Setup Key

R&S SMB General Instrument Settings
1407.0806.32 4.3 E-2
General Configuration of Instrument - Setup Key
The SETUP key opens the Setup menu. The Setup menu is divided into several sections.
- The System section is used to set general instrument parameters.
- The Test section is used to perform function tests.
- The Environment section is used to configure the controller interfaces.
- The Remote section is used to configure the remote control interfaces.
- The Protection is used to set the protection level for service functions.
- The Settings section contains the Save/Recall menu.
Most submenus of this key can be accessed only via the
SETUP key or the menu tree ( MENU key),
with the following exceptions:
- The Reference Oscillator submenu can also be called up in the RF block and is therefore
described in the section on this block (see section "RF Reference Frequency - Reference
Oscillator", page 4.30).
- The Save/Recall submenu can also be called up with the
FILE key and is therefore described in
the section on this key (see section "Storing and Loading Instrument Data - File Key", page 4.19).