General Instrument Settings R&S SMB
1407.0806.32 4.6 E-2
Remote-control command:
SYST:DISP:UPD OFF
Software / Options... - Setup-System
The Software / Options... menu shows the firmware version of the instrument software as well as all
installed hardware and software options.
Note:
Software options purchased at a later stage can be activated with a key code. The activation code is
supplied with the software option. How to install options is described in Chapter 4 of the Service
Manual (on CD ROM supplied with the instrument). The installation of hardware options purchased
at a later stage is also described in Chapter 4 of the Service Manual (supplied with the instrument).
Most hardware options need to be installed at an authorized Rohde&Schwarz service shop.
The Software / Options menu is opened using the SETUP or MENU key under System.
Remote-control commands:
*OPT?
Response:
"SMB-B106, SMB-K23, ...."
*IDN?
Response:
"Rohde&Schwarz,SMB100A,1400.0000k02/342988,2.02.0.0 (Release)"
To Next Page
Loading...
