Rohde & Schwarz SMB 100a - Page 88

General Instrument Settings R&S SMB
1407.0806.32 4.10 E-2
New Password - VNC
Enters the new password. The VNC password is required for remote
access to the instrument via Ultr@VNC (see chapter 1).
The default password is "instrument".
Remote-control commands: n.a.
Confirm New Password -
VNC
Enters the new password for conformation.
The new password is only valid after the Change Password button is
pressed.
Remote-control commands: n.a.
Old password - Security
Enters the currently used password. Default is '123456'.
The security password is required when changing the status of the
USB and LAN interface.
Remote-control commands: n.a.
New Password - Security
Enters the new password. Only numerics are permitted.
Remote-control commands: n.a.
Confirm New Password -
Security
Enters the new password for conformation.
The new password is only valid after the Change Password button is
pressed.
Remote-control commands: n.a.
USB Device - Security
Enables/disables the USB interfaces. Any device connected to the
USB interface is not recognized by the instrument when the interface
is disabled.
The setting requires the entry of the security password and is only
accepted after the Accept button is pressed.
Remote-control commands: n.a.
LAN Connection - Security
Enables/disables the LAN interfaces. Any device connected to the
LAN interface is not recognized by the instrument when the interface
is disabled.
The setting requires the entry of the security password and is only
accepted after the Accept button is pressed.
Remote-control commands: n.a.
Security Password
Enters the security password that is required to enable or disabled the
LAN or USB interface. Default is '123456'.
All settings are only accepted after the Accept button is pressed.
Remote-control commands: n.a.