RF Signal - RF R&S SMB
1407.0806.32 4.28 E-2
Variation Step - RF Signal
Sets the user-defined step width. This step width is used when
entering the RF frequency using the rotary knob. Frequency variation
with this step width must also be activated with Variation Active.
Remote-control command:
SOUR:FREQ:STEP 1 MHz
Variation Active
Activates the user-defined step width used when varying the
frequency value with the rotary knob.
ON
The frequency value set with the rotary knob is
varied using the user-defined step width which is
entered under Variation Step.
Remote-control command:
SOUR:FREQ:STEP:MODE USER
OFF
The frequency value set with the rotary knob is
varied in steps of one unit at the cursor position
(standard operating mode).
Remote-control command:
SOUR:FREQ:STEP:MODE DEC
To Next Page
Loading...
