Pulse Modulation R&S SMB
1407.0806.32 4.74 E-2
Pulse Period - Pulse
Generator
Sets the period of the generated pulse. The period determines the
repetition frequency of the internal signal.
Remote-control command:
SOUR:PULM:PER 0.05ms
Pulse Width - Pulse
Generator
Sets the width of the generated pulse. The width determines the pulse
length. The pulse width must be at least 20 ns less than the set pulse
period.
Remote-control command:
SOUR:PULM:WIDT 22ms
Pulse Delay - Pulse
Generator
Sets the pulse delay. The pulse delay determines the time that
elapses after a trigger event before pulse modulation starts. The pulse
delay is not effective for double pulse generation.
Remote-control command:
SOUR:PULM:DEL 22us
Double Pulse State - Pulse
Generator
Enables/disables double pulse generation. The two pulses are
generated in one pulse period.
Remote-control command:
SOUR:PULM:DOUB:STAT ON
Double Pulse Width - Pulse
Generator
(Double Pulse only)
Sets the width of the second pulse in case of double pulse generation.
Remote-control command:
SOUR:PULM:DOUB:WIDT 33 us
Double Pulse Delay - Pulse
Generator
(Double Pulse only)
Sets the delay from the start of the first pulse to the start of the second
pulse.
Remote-control command:
SOUR:PULM:DOUB:DEL 22us
Trigger Mode - Pulse
Generator
Selects the trigger mode for pulse modulation.
Auto
The pulse generator signal is generated
continuously.
Remote-control command:
SOUR:PULM:TRIG:MODE AUTO
Ext Triggered
The pulse generator signal is triggered by an
external trigger event. The trigger signal is supplied
via the PULSE EXT connector.
Remote-control command:
SOUR:PULM:TRIG:MODE EXT
To Next Page
Loading...
