Rohde & Schwarz SMB 100a - Page 217

R&S SMB Command Description
1407.0806.32 6.25 E-2
SOURce:CORRection Subsystem
The output level is corrected in the CORRection subsystem. Correction is performed by user-defined
table values being added to the output level for the respective RF frequency . In the
R&S Signal Generator, this subsystem is used to select, transfer and activate user correction tables
(see also Chapter 4).
Each list is stored as a file. The name of the user correction file can be freely selected. The file
extension *.uco is assigned automatically and cannot be changed.
The files can be stored in a freely selectable directory and opened from there. The default directory is
set using command MMEMory:CDIRectory. In the case of files which are stored in the default
directory, only the file name has to be specified in commands. Otherwise, the complete absolute path
has to be specified with every command. The extension can be omitted in any case.
Note:
In the following command examples, the files are stored in the default directory.
The keyword SOURce is optional with commands and can be omitted.
Command Parameters Default
unit
Remark
[SOURce:]CORRection:CSET:CATalog? - Query only
[SOURce:]CORRection:CSET:DATA:FREQuency 300 kHz...RF
max
{,300
kHz...RF
max
}
HZ
[SOURce:]CORRection:CSET:DATA:FREQuency:POINts? Query only
[SOURce:]CORRection:CSET:DATA:POWer -40 dB...6dB {,-40 dB...6 dB} dB
[SOURce:]CORRection:CSET:DATA:POWer:POINts? Query only
[SOURce:]CORRection:CSET:DELete <table name> No query
[SOURce:]CORRection:DEXChange:AFILe:CATalog? Query only
[SOURce:]CORRection:DEXChange:AFILe:EXTension TXT | CSV
[SOURce:]CORRection:DEXChange:AFILe:SELect <ASCII file name>
[SOURce:]CORRection:DEXChange:AFILe:SEParator:COL
umn
TABulator | SEMicolon |
COMMa | SPACe
[SOURce:]CORRection:DEXChange:AFILe:SEParator:DEC
imal
DOT | COMMa
[SOURce:]CORRection:DEXChange:EXECute No query
[SOURce:]CORRection:DEXChange:MODE IMPort | EXPort
[SOURce:]CORRection:DEXChange:SELect <ucor file>
[SOURce:]CORRection:CSET[:SELect] <table name>
[SOURce:]CORRection[:STATe] ON | OFF
[SOURce:]CORRection:VALue dB Query only