R&S SMB Command Description
1407.0806.32 6.59 E-2
[SOURce:]LIST:SELect '<list name>'
The command selects the specified list. If a new list is to be created, the name can be entered here.
The list is created if it does not yet exist. The list selected here is available for the further processing
steps (editing) and is used in the instrument when the List mode is activated.
The files are stored with the fixed file extensions *.lsw in a directory of the user's choice. The
directory applicable to the command is defined with the command MMEMory:CDIR. A path can also
be specified in command :SOUR:LIST:SEL in which case the list mode file in the specified
directory is selected.
*RST does not affect data lists.
Example
:
LIST:SEL ‘var/lists/listmode/list3'
'selects list3 for editing. List3 is created if it does not yet exist.
*RST value Resolution Options SCPI
- - Device-specific
[SOURce:]LIST:TRIGger:EXECute
The command immediately starts the processing of a list in list mode. It corresponds to the manual-
control command Execute Single. It is only valid for setting :LIST:MODE AUTO.
The command triggers an event and therefore has no reset value.
Example:
LIST:MODE STEP
'selects a full-cycle processing of the list.
SOUR:LIST:TRIG:EXEC
'triggers the processing of the selected list.
*RST value Resolution Options SCPI
- - Device-specific
To Next Page
Loading...
