R&S SMB Command Description
1407.0806.32 6.73 E-2
[SOURce:]PULM:DOUBle:DELay 20ns .. 1s
The command sets the delay from the start of the first pulse to the start of the second pulse.
Example:
PULM:DOUB:DEL 22 us
'22 us elapse between the beginning of the first pulse and the beginning of the
second pulse in double-pulse mode.
*RST value Resolution Options SCPI
1 ms 20 ns Option R&S SMB-K22 and R&S SMB-K23 Device-specific
[SOURce:]PULM:DOUBle:STATe ON | OFF
The command enables/disables double pulse generation. The two pulses are generated in one
pulse period.
Example:
PULM:DOUB:STAT ON 'double-pulse mode is enabled.
*RST value Resolution Options SCPI
OFF Option R&S SMB-K22 and R&S SMB-K23 Device-specific
[SOURce:]PULM:DOUBle:WIDTh 20ns .. 1s
The command sets the width of the second pulse in case of double pulse generation.
Example:
PULM:DOUB:WIDT 33 us 'sets a width of 33 us for the second pulse.
*RST value Resolution Options SCPI
1ms 20 ns Option R&S SMB-K22 and R&S SMB-K23 Device-specific
[SOURce:]PULM:PERiod 5µs .. 85.s | 100ns .. 85 s
The command sets the period of the generated pulse. The period determines the repetition
frequency of the internal signal.
Example:
PULM:PER 220 us 'the pulse period is 220 us.
*RST value Resolution Options SCPI
1 ms 1us | 20 ns Option R&S SMB-K22 and R&S SMB-K23 Device-specific
[SOURce:]PULM:POLarity NORMal | INVerted
The command sets the polarity between modulating and modulated signal. This command is only
effective for an external modulation signal.
Parameters: NORMal
The RF signal is suppressed during the pulse pause.
INVerted
The RF signal is suppressed during the pulse.
Example:
PULM:SOUR EXT 'selects the external modulation source.
PULM:POL INV 'selects inverted polarity.
*RST value Resolution Options SCPI
NORMal - Option R&S SMB-K22 Device-specific
To Next Page
Loading...
