R&S SMB Command Description
1407.0806.32 6.87 E-2
STATus:QUEStionable:ENABle
The command sets the bits of the ENABle part of the STATus:QUEStionable register. This setting
determines which events of the Status-Event part are enabled for the sum bit in the status byte.
These events can be used for a service request.
Example:
STAT:OPER:ENAB 1
'problems when performing an adjustment cause an entry to be made in the
sum bit.
*RST value Resolution Options SCPI
- - Compliant
STATus:QUEue[:NEXT]?
The command queries the oldest entry in the error queue and then deletes it. Positive error numbers
denote device-specific errors, and negative error numbers denote error messages defined by SCPI
(see Chapter 9). If the error queue is empty, 0 ("No error") is returned. The command is identical to
SYSTem:ERRor?.
Example:
STAT:QUE?
'queries the oldest entry in the error queue.
Response: "0, 'no error'"
'no errors have occurred since the error queue was last read out.
*RST value Resolution Options SCPI
- - Compliant
To Next Page
Loading...
