Rohde & Schwarz SMB 100a - Page 296

Command Description R&S SMB
1407.0806.32 6.104 E-2
UNIT Subsystem
The UNIT subsystem contains the commands specifying which units are valid if no unit is indicated in a
command. These settings are valid for the entire instrument.
Command Parameters Default
unit
Remark
UNIT:ANGLe DEG | RAD
UNIT:POWer V | DBM
UNIT:ANGle DEG | RAD
The command defines the default unit for angles. It is valid for all commands which determine angle
values. It does not influence the manual control parameter unit and the display.
Example:
UNIT:ANGL DEG
'sets default unit DEG for all commands which determine angle values.
*RST value Resolution Options SCPI
RAD - Compliant
UNIT:POWer V | DBM
The command defines the default unit for power. It is valid for all commands which determine power
values. It does not influence the manual control parameter unit and the display.
Example:
UNIT:POW V
'sets default unit V for all commands which determine power values.
*RST value Resolution Options SCPI
DBM - Compliant