R&S SMB Remote Access via an External Controller
1407.0812.62 1.23 E-2
5. Enter the VNC password defined in the Environment-Security section of the Setup menu of
R&S SMB (default = "instrument"). The connection is established when the Log On button is
pressed. .
After the connection is established, the current signal generator screen with the block diagram is
displayed and the R&S SMB can be manually remote-controlled from the external PC. The individual
functions are operated using the mouse and keyboard. Specific instrument functions can be
executed using specific key combinations on the keyboard (see table in Chapter 3, section "Legend
of Front-Panel Controls"). Direct control on the R&S SMB is possible while manual remote-control is
established, it can be performed alternately with the remote access.
Close Remote Access Connection via Ultr@VNC
The connection can be closed on the external PC by closing the VNC Viewer program.
Closing the connection does not disable it. It can be established again any time.
To Next Page
Loading...
