R&S SMC100A Sweep Mode
1411.4060.32 4.79 E-4
Step - RF Level Sweep
Sets the step width for the individual sweep steps. This entry is
effective for all sweep modes.
With the level sweep, the logarithmic step width is a constant fraction
of the current level. This fraction is added to the current level. The
logarithmic step width is entered in dB.
Remote-control command:
SOUR:SWE:POW:STEP 3
Dwell Time - RF Level
Sweep
Enters the dwell time. The dwell time determines the duration of the
individual sweep steps.
Note:
It is recommended to switch off the GUI update for optimum sweep
performance especially with short dwell times.
Remote-control command:
SOUR:SWE:POW:DWEL 10ms
Ext Trigger Input
Slope
Sets the polarity of the active slope of an applied instrument trigger.
This setting affects the INST TRIG input (BNC connector at the rear of
the instrument).
Positive
The rising edge of the trigger signal is active.
Remote-control command:
SOUR:INP:TRIG:SLOP POS
Negative
The falling edge of the trigger signal is active.
Remote-control command:
SOUR:INP:TRIG:SLOP NEG
To Next Page
Loading...
