Sweep Mode R&S SMC100A
1411.4060.32 4.78 E-1
The sweep range, sweep spacing and dwell time are set in the bottom section.
Start Level - RF Level
Sweep
Sets the start level.
Remote-control command:
SOUR:POW:STAR -100
Stop Level – RF Level
Sweep
Sets the stop level.
Remote-control command:
SOUR:POW:STOP -10
Current Level - RF
Level Sweep
Displays the current level.
If Step is set, the level for the next level step of the sweep is entered
here.
Remote-control command:
SOUR:POW:MAN -30
Shape - RF Level
Sweep
Selects the cycle mode for a sweep sequence (shape).
Sawtooth One sweep runs from the start level to the stop level.
The subsequent sweep starts at the start level
again, i.e. the shape of sweep sequence resembles
a sawtooth.
Remote-control command:
SOUR:SWE:POW:SHAP SAWT
Triangle One sweep runs from start to stop level and back,
i.e. the shape of the sweep resembles a
triangle.Each subsequent sweep starts at the start
level again.
Remote-control command:
SOUR:SWE:POW:SHAP TRI
To Next Page
Loading...
