Command Description R&S SMC100A
1411.4060.32 6.92 E-1
SYSTem:COMMunicate:NETWork:IPADdress:MODE STATic | AUTO
The command selects if the IP address is assigned automatically or manually. The entry is only
activated after sending command SYST:COMM:NETW:IPAD:SET.
Parameters: AUTO
The IP address is assigned automatically. The network used must support
automatic assignment of address (DHCP) in order to use this function.
STATic
The IP address is assigned manually.
P2P
A Peer to Peer connection is used.
Example:
SYST:COMM:NETW:IPAD:MODE AUTO
' the IP address is assigned automatically (DHCP).
SYST:COMM:NETW:IPAD:SET ON
'activates DHCP.
*RST value Resolution Options SCPI
AUTO - Device-specific
SYSTem:COMMunicate:NETWork:IPADdress:SET
The command activates the IP settings (Commands SYST:COMM:NETW:IPAD:..).
The command triggers an event and therefore has no *RST value and no query form.
Example:
SYST:COMM:NETW:IPAD:SET
'activates all changes of the IP adress settings.
*RST value Resolution Options SCPI
- - Device-specific
SYSTem:COMMunicate:NETWork[:IPADdress]:SUBNet:MASK 0.0.0.0 .. FF.FF.FF.FF
The command enters the Subnet mask. The entry is only activated after sending command
SYST:COMM:NETW:IPAD:SET.
Example:
SYST:COMM:NETW:SUBN:MASK 255.255.255.0
'enters the Subnet mask.
SYST:COMM:NETW:IPAD:SET
'activates all changes of the IP address settings.
*RST value Resolution Options SCPI
- Device-specific
To Next Page
Loading...
