R&S SMC100A Command Description
1411.4060.32 6.91 E-1
SYSTem:COMMunicate:NETWork:GET
The command retrieves the current network settings. They can be queried with the corresponding
commands.
The command triggers an event and therefore has no *RST value and no query form.
Example:
SYST:COMM:NETW:GET
'
retrieves the current network settings.
*RST value Resolution Options SCPI
- - Device-specific
SYSTem:COMMunicate:NETWork:IPADdress 0.0.0.0 .. FF.FF.FF.FF
The command enters the IP address . The entry is only activated after sending command
SYST:COMM:NETW:IPAD:SET.
Example:
SYST:COMM:NETW:IPAD 7.8.9.10
'enters the IP address of the R&S SMC.
SYST:COMM:NETW:IPAD:SET
'activates all changes of the IP address settings.
*RST value Resolution Options SCPI
- Device-specific
SYSTem:COMMunicate:NETWork[:IPADdress]:GATeway 0.0.0.0 .. FF.FF.FF.FF
The command enters the IP address of the default gateway. The entry is only activated after
sending command SYST:COMM:NETW:IPAD:SET.
Example:
SYST:COMM:NETW:GAT 1.2.3.4
'enters the IP address of the default gateway.
SYST:COMM:NETW:IPAD:SET
'activates all changes of the IP address settings.
*RST value Resolution Options SCPI
28 - Device-specific
To Next Page
Loading...
