Command Description R&S SMC100A
1411.4060.32 6.90 E-1
SYSTem:COMMunicate:NETWork:DNS:MODE STATic | AUTO
The command selects if the DNS server address is assigned automatically or manually. The entry is
only activated after sending command SYST:COMM:NETW:DNS:SET.
Parameters: AUTO
The DNS server address is assigned automatically. The network used must
support automatic assignment of address (DHCP) in order to use this function.
STATic
The DNS server address is assigned manually.
Example:
SYST:COMM:NETW:DNS:MODE AUTO
' the DNS server address is assigned automatically (DHCP).
SYST:COMM:NETW:COMM:SET ON
'activates DHCP.
*RST value Resolution Options SCPI
AUTO - Device-specific
SYSTem:COMMunicate:NETWork:DNS:PREFerred 0.0.0.0 .. FF.FF.FF.FF
The command sets the preferred DNS server address manually. The entry is only activated after
sending command SYST:COMM:NETW:DNS:SET.
Example:
SYST:COMM:NETW:DNS:MODE STAT
' the DNS server address is assigned manually.
SYST:COMM:NETW:DNS:PREF 7.8.9.10
'sets the IP address of the preferred DNS server.
SYST:COMM:NETW:COMM:SET ON
'activates the above settings.
*RST value Resolution Options SCPI
- - Device-specific
SYSTem:COMMunicate:NETWork:DNS:SET
The command activates the DNS setting (Commands SYST:COMM:NETW:DNS:..).
The command triggers an event and therefore has no *RST value and no query form.
Example:
SYST:COMM:NETW:DNS:SET
'activates all changes of the DNS settings.
*RST value Resolution Options SCPI
- - Device-specific
To Next Page
Loading...
