Rohde ST 410 - ROHDEgraph Software; General Information on ROHDEgraph; Controller Status Codes in ROHDEgraph

72 / 291 - EN -
10.3. ROHDE graph
10.3.1. General information
ROHDEgraph is computer software for the visualisation and archiving of firing curves from the recorded measured
values of the control system.
Record data
7 K
The firing data is automatically recorded during firing with the
controller and a USB flash drive.
Transfer to PC
N
The logfile from the controller can be transferred to the PC with a
USB flash drive.
Evaluate and
save
X
The log data is processed on the computer with ROHDEgraph in
Excel and displayed as a firing curve.
System
Z
Windows/Mac and a current version of Microsoft Excel.
Information, function and software download at:
www.rohde.eu/graph
10.3.2. Meaning of the controller status codes in ROHDEgraph
Folgende Bedeutungen haben die Werte in der Spalte “Controller Status” im Log-File von ROHDEgraph. In the
ROHDEgraph log file, the values in the “Controller Status” column have the following meanings.
Code-Number Description
1
The controller is in idle (no program is running).
2
The controller performs a start delay.
7
The controller performs a heating ramp.
8
The control program has/was paused during a heating ramp.
9
The controller performs a cooling ramp.
10
The control program has/was paused during a cooling ramp.
11
The controller performs a soak time.
12
The control program has/was paused during a soak time.
13
After the end of a program, the kiln cools down but the temperature is still above 40 °C.
14
The kiln has cooled down, the temperature is below 40 °C.
15
The controller displays the error message "Error 0” (internal data error).
16
The controller displays the error message "Error 1“ (heating up to slow).
17
The controller displays the error message "Error 2“ (thermocouple failure)).
18
The controller displays the error message "Error 3“ (thermocouple reversed).
19
The controller displays the error message "Error 4“ (cooling down to slow).