Roth EnergyLogic Touchline/wireless - Page 79

User Manual Roth EnergyLogic Touchline/Wireless
Parameter descriptions
P100011294 E 79
Parameter Description
P-06 Set display for stand-by-mode. (max. battery saving mode)
To minimize battery consumption the display can be switched off in stand-by- mode.
Only the symbol "low battery" will be shown when applicable.
• Factory settings: option "On"
• Options
– On: normal, as defined with parameter P-01.
– Off: no symbols are shown (max. battery saving mode)
Operation
► Press sensor button . The display shows shortly diSP and then On.
► Press sensor button
or , to select option On or OFF.
► Press sensor button to confirm selection. The display shows P-07.
P-07 Activate or deactivate sound of sensor button.
• Factory settings: Option "On"
• Options
– On: activate
– OFF: deactivate
Operation
► Press sensor button . The display shows On.
► Press sensor button or , to select option On or OFF.
► Press sensor button
to confirm selection. The display shows P-08.
P-08 Show ID-number of wireless room thermostat.
This ID-Number is needed to configure a smart phone web-application!
Operation
► Press sensor button
. The display shows the ID-number.
► Press sensor button
. The display shows P-09.
P-09 Show ID-number of wireless connection module.
This ID-Number is needed to configure a smart phone web-application!
Operation
► Press sensor button
. The display shows the ID-number.
► Press sensor button
. The display shows P-10.