Roth EnergyLogic Touchline/wireless - Page 90

User Manual Roth EnergyLogic Touchline/Wireless
Parameter descriptions
90 P100011294 E
Parameter Description
P-46 Activate or deactivate "setpoint sharing within one zone".
 Refer to also page 121, chapter 16.
Setpoint sharing is typically used for large rooms that have different temperature
profiles for different parts of the room. The room is divided into several heating
zones each with its own wireless room thermostat. Each heating zone will control
the part of the room according to its own control loop. However, all setpoints are the
same. A change of the setpoint at one wireless room thermostat initiates a change
of all relevant wireless room thermostats. All relevant room thermostats need to be
within one zone of the wireless connection module and enabled for setpoint sharing
by the settings of parameter P-46.
● Factory settings: Option "0"
● Options:
– 0: deactivate
– 1: activate
Operation
► Press sensor button . The display shows 0.
► Press sensor button or , to select option 0 or 1.
► Select one of the following options:
– Press sensor button , to save the changed settings. The display shows the
next parameter P-47.
– Press sensor button , to interrupt the procedure. The display shows the se-
lected parameter.
P-47 Activate or deactivate lock for public spaces or hotels.
● Factory settings: Option "0"
● Options:
– 0: deactivate lock.
– 1: activate lock for public spaces.
All sensor buttons are locked. When pressing sensor button
the access
code for public spaces is prompted.  See parameter description P-36,
page 86.
– 2: activate lock for hotels.
All sensor buttons except for sensor buttons and are locked. With sen-
sor buttons
and it is possible to change the room temperature setpoint.
When pressing sensor button
the access code for public spaces is
prompted.  See parameter description P-36, page 86.
Operation
► Press sensor button
. The display shows 0.
► Press sensor button
or , to select option 0, 1 or 2.
► Select one of the following options:
– Press sensor button , to save the changed settings. The display shows the
next parameter P-48.
– Press sensor button , to interrupt the procedure. The display shows the se-
lected parameter.