Royal Alpha 710ML - Entering and Exiting Training Mode

Alpha 710ML User’s Guide 68
Using Training Mode
Entering and Exiting Training Mode
After a training passcode is programmed, you can enter and exit Training
mode.
When the cash register is in Training mode, a symbol appears in the lower
left of the clerk screen. Some transactions may also print DEMO or asterisks
**** on the receipt.
To start Training mode
1 Press the Main menu (on) key.
2 Select Sales Registration. Press the Amount Tend Total <Enter> key.
3 If the clerk numbers are set, do the following:
• Enter the clerk number and then press the Amount Tend Total <enter>
key.
• Using the round Number keys, press the three digit passcode and then
press the Check key.
4 Using the Round number keys, enter the 6 digit passcode. Press the
Subtotal reprint key. The TR symbol appears on the screen.
5 Now you can ring up sales in training mode. These sales do not appear in
the sales reports.
To stop Training mode
1 Press the Main menu (on) key.
2 Select Sales Registration. Press the Amount Tend Total <Enter> key.
3 If the clerk numbers are set, do the following:
• Enter the clerk number and then press the Amount Tend Total <enter>
key.
• Using the round Number keys, press the three digit passcode and then
press the Check key.
4 Using the Round number keys, enter the 6 digit passcode. Press the
Subtotal reprint key. The TR symbol disappears from the screen.
5 Now you can ring up sales normally. These sales do appear on sales
reports.