SAMSUNG Programming
DCS-816 February, 1999
MMC 800 (Page 1 of 2)
MMC: 800 ENABLE TECHNICIAN
PROGRAM
DESCRIPTION:
Used to open and close technician–level programming. If programming is not
opened and an attempt is made to access a system MMC, the error message
“ACCESS DENIED” will be displayed.
A four digit passcode is required to access this MMC. Each character can be
digits 0–9. When opened, this MMC enables access to all MMCs.
When the system was installed, the Country Code should have been selected
using MMC 812 before any other programming was done. If this is not the
case, MMC 800 will require the installer to enter the code before continuing.
After selecting the code, the system restarts and all default data are changed
to new data for the selected country.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
ACTION DISPLAY
1. Press TRSF 800
Display shows
ENABLE TECH.PROG
PASSCODE:
2. Enter passcode
Correct code shows
Incorrect code shows
ENABLE TECH.PROG
PASSCODE:
QQQQ
ENABLE TECH.PROG
DISABLE
ENABLE TECH. PROG
PASSCODE ERROR
To Next Page
Loading...
