SAMSUNG Programming
DCS-816 February, 1999
MMC 801 (Page 1 of 1)
MMC: 801
CHANGE TECHNICIAN PASSCODE
DESCRIPTION:
Used to change the passcode which allows access to MMC 800 (Enable
Technician Program) from its current value.
NOTE: The passcode is four characters long. Each character can be digits 0–9.
The current or “old” passcode is required for this MMC.
PROGRAM KEYS
KEYPAD Used to enter passcodes
SPK Save data and advance to next MMC
ACTION DISPLAY
1. Press TRSF 801
TECH. PASSCODE
NEW CODE:_
2. Enter new passcode
TECH. PASSCODE
NEW CODE:
QQQQ
3. Enter new passcode again
TECH. PASSCODE
VERIFY : :
QQQQ
4. If passcode is correct, press RIGHT soft key to
continue and enter desired MMC
TECH. PASSCODE
VERIFY :SUCCESS
If passcode is incorrect
TECH. PASSCODE
VERIFY :FAILURE
System returns to step 2
TECH. PASSCODE
NEW CODE: :
QQQQ
5. Press TRSF to store and exit
OR
Press SPK to advance to MMC
DEFAULT DATA: Default passcode = 4321
RELATED ITEMS: MMC 800 Enable Technician Program
To Next Page
Loading...
