Santec TSL-710 - Page 76

7-22
TSL-710 Operation Manual
9) *SRE Service Request Enable Register Setting
Syntax *SRE<wsp><value>
Description Sets the Service Request Enable Register (SRER).
Parameter Setting value from 0 to 255
Response None
10) *SRE? Service Request Enable Register Query
Syntax *SRE?
Description Places the value of the Service Request Enable Register
(SRER) in the output queue.
Parameter None
Response Integer from 0 to 63, or 128 to 191.
(Values are missing since Bit 6 is always 0.)
11) *STB? Status Byte Register Query
Syntax *STB?
Description Places the value of the Status Byte Register (STBR) in the
output queue.
Parameter None
Response Integer from 0 to 255
When read out by a serial poll, the value returned is the sum
of 64 and the value of the Status Byte Register (since Bit 6 is
set in the serial poll).