Santec TSL-710 - Page 77

Tunable Semiconductor Laser TSL-710
7-23
4. TSL-710 Specic command overview
An overview of the specic commands available in Command set 1 is shown in
the following table.
TSL-710 Specic Command List (Command set 1 Group)
Command Description Page
:SPECial:REBoot Resets the device. 7-26
:SYSTem:ERRor? Reads out the error issued. 7-26
:SYSTem:VERSion? Reads out the version of the rmware. 7-26
:SYSTem:COMMunicate:GPIB:ADDRess Sets the GPIB address. 7-26
:SYSTem:COMMunicate:GPIB:ADDRess? Reads out the GPIB address. 7-26
:SYSTem:COMMunicate:GPIB:DELimiter
Sets the command delimiter for GPIB
communication.
7-27
:SYSTem:COMMunicate:GPIB:DELimiter?
Reads out the command delimiter for GPIB
communication.
7-27
:SYSTem:COMMunicate:SERial:SPEed Sets the speed of serial communication. 7-27
:SYSTem:COMMunicate:SERial:SPEed?
Reads out the speed of serial
communication.
7-28
:SYSTem:
COMMunicate:SERial:DELimiter
Sets the command delimiter for serial
communication.
7-28
:SYSTem:COMMunicate:SERial:DELimiter?
Reads out the command delimiter for serial
communication
7-28
:TRIGger:INPut:EXTernal
Sets Enable/Disable of the external trigger
signal input.
7-29
:TRIGger:INPut:EXTernal?
Reads out the setting of the external trigger
signal input.
7-29
:TRIGger:INPut:STANdby
Puts the device in trigger signal input
standby mode
7-29
:TRIGger:INPut:STANdby?
Reads out the trigger signal input standby mode. 7-29
:TRIGger:OUTPut Sets the timing of the trigger signal output. 7-30
:TRIGger:OUTPut?
Reads out the timing setting of the trigger
signal output.
7-30
:TRIGger:OUTPut:STEP[:WIDTh] Sets the interval of the trigger signal output. 7-30
:TRIGger:OUTPut:STEP[:WIDTh]?
Reads out the interval of the trigger signal output. 7-30
[:SOURce]:COHCtrl Turns ON/OFF the coherence control. 7-31
[:SOURce]:COHCtrl? Reads out the state of the coherence control. 7-31
[:SOURce]:POWer:STATe Sets ON/OFF the LD. 7-31
[:SOURce]:POWer:STATe? Reads out the ON/OFF status of the LD. 7-31
[:SOURce]:POWer:ATTenuation Sets the attenuator value. 7-32
[:SOURce]:POWer:ATTenuation? Reads out the attenuator value. 7-32
[:SOURce]:POWer:ATTenuation:AUTo
Switches to Auto/Manual for the power control. 7-32
[:SOURce]:POWer:ATTenuation:AUTo? Reads out the setting of the power control. 7-32
[:SOURce]:POWer:SHUTter Sets Open/Close status of the internal shutter. 7-33