Santec TSL-710 - Page 78

7-24
TSL-710 Operation Manual
Command Description Page
[:SOURce]:POWer:SHUTter? Reads out the status of the internal shutter. 7-33
[:SOURce]:POWer:UNIT
Changes the unit of the power setting and
display.
7-33
[:SOURce]:POWer:UNIT?
Reads out the unit of the power setting and
display.
7-33
[:SOURce]:POWer[:LEVel] Sets the optical output power. 7-34
[:SOURce]:POWer[:LEVel]?
Reads out the setting value of the optical
output power.
7-34
[:SOURce]:POWer[:LEVel]:MINimum? Reads out the minimum available power. 7-34
[:SOURce]:POWer[:LEVel]:MAXimum? Reads the maximum available power. 7-34
[:SOURce]:POWer:ACTual[:LEVel]?
Reads out the setting value of the optical
output power.
7-34
[:SOURce]:POWer:CORRection:PROFile
Revises the compensate power data of
sweeps in auto power mode.
7-35
[:SOURce]:WAVelength:UNIT Sets the unit of the wavelength indication. 7-35
[:SOURce]:WAVelength:UNIT?
Reads out the unit setting of the wavelength
indication.
7-35
[:SOURce]:WAVelength Sets the output wavelength. 7-36
[:SOURce]:WAVelength?
Reads out the setting value of the
wavelength.
7-36
[:SOURce]:WAVelength:MINimum?
Reads out the minimum acceptable
wavelength.
7-36
[:SOURce]:WAVelength:MAXimum?
Reads out the maximum acceptable
wavelength.
7-36
[:SOURce]:WAVelength:FINe Sets the ne-tuning 7-36
[:SOURce]:WAVelength:FINe?
Reads out the setting value of the ne-
tuning.
7- 36
[:SOURce]:WAVelength:FINe:DISable Disables the ne-tuning. 7-37
[:SOURce][:WAVelength]:FREQuency
Sets the output wavelength in optical
frequency.
7-37
[:SOURce][:WAVelength]:FREQuency?
Reads out the output wavelength in optical
frequency.
7-37
[:SOURce][:WAVelength]:FREQuency:MINimum?
Reads out the minimum acceptable
frequency.
7-37
[:SOURce][:WAVelength]:FREQuency:MAXimum?
Reads out the maximum acceptable
frequency.
7-37
[:SOURce]:WAVelength:SWEep:CYCLes Sets the number of wavelength sweeps. 7-38
[:SOURce]:WAVelength:SWEep:CYCLes?
Reads out the setting of the number of
wavelength sweeps.
7-38
[:SOURce]:WAVelength:SWEep:COUNt?
Reads out the current number of completed
sweeps.
7-38
[:SOURce]:WAVelength:SWEep:DELay
Sets the wait time between each sweep in
continuous sweep operation.
7-38