Santec TSL-710 - Page 90

7-36
TSL-710 Operation Manual
Example :WAV:UNIT?
→ 1
Indicates that the wavelength unit is THz.
[:SOURce]:WAVelength
Syntax [:SOURce]:WAVelength<wsp><value>
Description Sets the output wavelength.
Parameter Range：Range: Minimum setting wavelength
to Maximum (nm)
Step：0.0001 (nm)
Response None
Example :WAV 1550
Sets the output wavelength to 1550 nm.
[:SOURce]:WAVelength?
Syntax [:SOURce]:WAVelength[:MINimum|:MAXimum]?
Description Reads out the setting value of the wavelength.
Parameter None: Reads out the currently set wavelength.
MINimum:
Reads out the minimum acceptable wavelength.
MAXimum:
Reads out the maximum acceptable wavelength.
Response Range：Minimum acceptable wavelength
to Maximum acceptable wavelength (nm)
Step：0.0001 (nm)
Example :WAV?
→ 1550.000
Indicates that the currently set wavelength is 1550 nm.
[:SOURce]:WAVelength:FINe
Syntax [:SOURce]: WAVelength:FINe <wsp> <value>
Description Sets the ne-tuning.
Parameter Range：-100.00 〜 +100.00 (Unit: None)
Step：0.01 (Unit: None)
Response None
Example :WAV:FIN 50
Sets the ne-tuning to 50.
[:SOURce]:WAVelength:FINe?
Syntax [:SOURce]:WAVelength:FINe?
Description Reads out the setting value of the ne-tuning.
Parameter None