Santec TSL-710 - Page 92

7-38
TSL-710 Operation Manual
[:SOURce]:WAVelength:SWEep:CYCLes
Syntax
[:SOURce]:WAVelength:SWEep: CYCLes <wsp> <value>
Description Sets the number of wavelength sweeps.
Parameter Range：0 〜 999
Step：1
Response None
Example :WAV:SWE:CYCL 100
Sets the number of sweeps to100.
[:SOURce]:WAVelength:SWEep:CYCLes?
Syntax [:SOURce]:WAVelength:SWEep:CYCLes?
Description Reads out the setting of the number of
wavelength sweeps.
Parameter None
Response Range：0 〜 999
Step：1
Example :WAV:SWE:CYCL?
→ 100
Indicates that the number of sweeps is set to 100.
[:SOURce]:WAVelength:SWEep:COUNt?
Syntax [:SOURce]:WAVelength:SWEep:COUNt?
Description Reads out the current number of completed sweeps.
Parameter None
Response Range：0 〜 999
Step：1
Example :WAV:SWE:COUN?
→ 100
Indicates that 100 sweeps have completed.
[:SOURce]:WAVelength:SWEep:DELay
Syntax [:SOURce]:WAVelength:SWEep: DELay <wsp> <value>
Description Sets the wait time between each sweep in continuous
sweep operation.
Parameter Range：0 〜 999.9 (s)
Step：0.1 (s)
Response None
Example :WAV:SWE:DEL 1
Sets the wait time to 1 second.