Santec TSL-710 - Page 94

7-40
TSL-710 Operation Manual
Response None
Example :WAV:SWE:MOD 1
Sets the sweep mode to Continuous operation,
One-way mode.
[:SOURce]:WAVelength:SWEep:MODe?
Syntax [:SOURce]:WAVelength:SWEep:MODe?
Description Reads out the sweep operation mode.
Parameter None
Response 0: Step operation, One-way
1: Continuous operation, One-way
2: Step operation, Two-way
3: Continuous operation, Two-way
Example :WAV:SWE:MOD?
→ 1
Indicates that the sweep mode is set to Continuous
operation, One-way.
[:SOURce]:WAVelength:SWEep:SPEed
Syntax [:SOURce]:WAVelength:SWEep:SPEed <wsp> <value>
Description Sets the speed for continuous sweep.
Parameter Range：0.5 〜 100 (nm/s)
Step：0.1 (nm/s)
Response None
Example :WAV:SWE:SPE 100
Sets the sweep speed to 100 nm/s.
[:SOURce]:WAVelength:SWEep:SPEed?
Syntax [:SOURce]:WAVelength:SWEep:SPEed?
Description Reads out the speed of continuous sweep.
Parameter None
Response Range：0.5 〜 100 (nm/s)
Step：0.1 (nm/s)
Example :WAV:SWE:SPE?
→ 100.000
Indicates that the sweep speed is set to 100 nm/s.